Armattan Chameleon 5" FPV Drone Frame (Orange) – Drone.Parts Store
Cart 0

Armattan Chameleon 5" FPV Drone Frame (Orange)


  • $95.00

  • "low-rider" style top-plate. This lowered mount gets the battery closer to the center of gravity for this machine. This means your rolls and flips will be snappier, and less likely to over-rotate. An unexpected (but very welcome) feature of the recessed top-plate is that the camera cage will be more likely to protect your battery in the event of an upside-down impact.

  • Speaking of the camera cage, the 4mm thick, 6061 aluminum structure on the front of this frame corners the market for providing the most protection and versatility in mounting your cameras. Not only will your frame fully protect your FPV camera above 25 degrees but it allows for near unlimited vertical play. HD camera mounting plate allows you to adjust the angle of your recording device from 30 up to 60 degrees.

  • the VTX mount on the rear of the bus. Cut into the carbon fiber top-plate are a set of holes that line up above where you will mount your VTX. These were carefully measured to align with the screens, dip-switches, and buttons of many popular transmitters on the market today (Hawkeye, Aomway, etc). We think changing your channel at the field should be as quick and easy as changing your camera angle. This helps us achieve that goal.

  • Lifetime warranty


Lifetime Warranty

In the unfortunate instance that you meet the ground at a high rate of speed (and damage does occur), Armattan is offering a full bumper-to-bumper warranty for the Chameleon frame. Included in the list price is a warranty that covers all of the pieces (both Carbon Fiber AND Aluminum) for that added peace of mind.

Note: Parts would be warrantied by Armattan (original manufacturer) through here




  • 1x 4mm Main Plate
  • 1x 2mm Lipo Top Plate
  • 1x Aluminum VTX mount
  • 2x Rubber SMA O-Rings
  • 16x M3 6mm motor bolts
  • 4x M3 nylon 12mm bolts
  • 4x M3 nylon 6mm male/female standoffs
  • 8x M3 nylon nuts
  • 2x M3 6mm cuphead iron bolts
  • 4x M2 5mm cuphead bolts
  • 2x M3 7mm countersunk bolts


Camera Cage
  • 1x HD Cam Top Plate
  • 2x 1.5mm Cam Braces
  • 2x 4mm Aluminum Cam Protector
  • 2x 4mm Aluminum HD Cam Lever
  • 2x rubber dimes
  • 8x M2 5mm cuphead bolts
  • 2x M2 5mm bolts
  • 2x M2 washers
  • 2x M3 sunknuts
  • 2x M3 aluminum thumbscrew
  • 2x M3 8mm iron bolts
  • 4x M2 10mm cuphead bolts
  • 4x M3 10mm iron bolts


Stack Hardware
  • 8x M3 rubber FC O-rings


Foam and Rubber Protection
  • 4x Foam Landing Pads
  • 1x Lipo Top Plate Foam Pad
  • 1x HD Cam Foam Pad